RADIAL Engineering J48 J48TM phantom powered active direct box

photo_742

Exceptional headroom & dynamic range Retains instrument’s natural sound The perfect DI for bass & acoustic guitar Powered by 48V phantom Ultra low distortion of all types
En savoir +

 

AKG C214
Statique Cardioïde

Banderole_C214_Druck

Professional studio recording
Lead vocals
Lead instruments
Ensemble recording
Professional stage miking
Drum overhead miking

  • AKG’s Legendary 1” Edge-Terminated Large Diaphragm Sound
  • Outstanding Dynamic Range (up to 156 dB SPL, Ultra-Low Noise)
  • Roadworthy Design
  • Integrated Suspension to reduce mechanical Noise
  • Switchable 20 dB Attenuation Pad and Low Cut Switch
  • Rugged double mesh Grill for high RF immunity but unaffected Acoustics
  • All-metal Die-cast body with shock- and scratch-resistant Finish
  • Spider-type Shock Mount included
  • Metal Carrying Case included
  • Designed, Engineered and Built in Vienna, Austria

En savoir +

 

NEUMANN KM184
Statique Cardioïde

photo_596Le modèle KM 184 (de directivité cardioïde), en particulier, est devenu un classique dans le domaine des microphones miniatures de haute qualité.

En savoir +

 

 

SHURE SM81LC
Statique Cardioïde

photo_610

  • 0 Hz to 20 kHz frequency response
  • Flat response curve for accurate reproduction of sound sources
  • Low noise and high output clipping level
  • Low distortion over a wide range of load impedances
  • Cardioid polar pattern, uniform with frequency and symmetric about axis, providing maximum
  • rejection and minimum coloration of off-axis sounds
  • Low RF susceptibility
  • Selectable low-frequency response: flat, 6 or 18 dB/octave rolloff
  • 0 dB/10 dB lockable attenuator switch
  • Phantom powering (DIN 45 596 voltages of 12 to 48 Vdc)
  • Rugged steel construction for durability
  • Field-usable over wide range of temperature and humidity conditions

En savoir +

SHURE UR2/Béta58A
Wirelees SuperCardioïde

photo_611

  • Supercardioid, Dynamic
  • Frequency response: 50 to 16,000 Hz
  • Neodymium magnet for high signal–to–noise output
  • RF Carrier Frequency Range: 470 – 952 MHz
  • Switchable RF Power (10/50 mW), country dependent
  • Battery Life: Up to 9.5 hours continuous use

En savoir +

BEYERDINAMIC M88TG
Dynamic Cardioïde

photo_608

transducer type Dynamic
Operating principle Pressure gradient
Frequency response (close miking) 30 – 20,000 Hz
Polar pattern Hypercardioid
Side attenuation > 23 dB at 120°
Open circuit voltage at 1 kHz (0dB = 1V/Pa) 2.9 mV/Pa ≡ -30.7 dBV
Magnetic field suspension >20 dB ≡ 50 Hz
Nominal impedance 200 Ω
Diaphragm Hostaphan®
Case/finish Brass
Connector 3-pin XLR

 

En savoir +

 

ElectroVoice RE20
Dynamic Cardioïde

photo_603

Element Dynamic
Polar Pattern Cardioid
Impedance, Low-Z balanced 150 Ohms
Connector Type 3-pin XLR
Open Circuit Voltage 1.5 mV/Pascal
Finish Fawn Beige
Case Material Steel
Weight Net 737 g ( 26 oz )
Dimensions (Height X Max Diameter) 217 x 54 mm
(8.54″ x 2.13″)

Microphone Applications:

Accordion, Acoustic Strings, Brass, Guitar Amp, Kick Drum, Snare, Speech, Tom, Woodwinds

En savoir +

 

SENNHEISER MD441U
Dynamic SuperCardioïde

photo_609

  • Très grande linéarité
  • Suppression maximum des réactions acoustiques
  • Insensible aux bruits mécaniques, grâce à la suspension élastique de la capsule
  • Bobine de compensation du ronflement
  • Atténuateur de graves à 5 paliers
  • Commutateur de brillance
  • Protection anti-plosives intégrée

En savoir +

 

SENNHEISER MD421
Dynamic Cardioïde

photo_605

Principe du transducteur dynamique
Directivité cardioïde
Réponse en fréquence 30…..17000 Hz
Sensibilité en champ libre 2 mV/Pa +- 3 dB
Impédance nominale 200 Ohm
Impédance de charge minimale 200 Ohm
Connecteur XLR-3
Dimensions 215 x 46 x 49 mm

En savoir +

 

SHURE Béta91
Statique Cardioïde

 

The Beta 91 combines superior « attack » and « punch » for studio quality sound, even at the extremely high sound pressure levels encountered inside a kick drum. Its boundary effect design produces a strong, solid low-end response that has been specifically tailored for heavy bass applications.

photo_597

  • Frequency response shaped specifically for kick drums and other instruments
  • Wide dynamic range for use in high SPL environments
  • Low-profile design requires no external mounting hardware
  • Detachable cable for easy storage
  • Legendary Shure quality, ruggedness, and reliability

En savoir +

 

SHURE Béta52
Dynamic SuperCardioïde

photo_598

  • Frequency response shaped specifically for kick drums and bass instruments
  • Built–in dynamic locking stand adapter with integral XLR connector simplifies setup, especially inside a kick drum
  • Studio quality performance, even at extremely high sound pressure levels
  • Supercardioid pattern for high gain before feedback and superior rejection of unwanted noise
  • Hardened steel mesh grille that resists wear and abuse
  • Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
  • Neodymium magnet for high signal–to–noise ratio output
  • Low sensitivity to varying load impedance
  • Legendary Shure quality and reliability

En savoir +

SHURE SM57 LC
Dynamic Cardioïde

 

  •  Contoured frequency response for clean, instrumental reproduction and rich vocal pickup
  • Professional-quality reproduction for drum, percussion, and instrument amplifier miking
  • Uniform cardioid pickup pattern isolates the main sound source while reducing background noise
  • Pneumatic shock-mount system cuts down handling noise
  • Extremely durable under the heaviest use
  • Frequency response: 40 to 15,000 Hz

En savoir +

 

SHURE Béta57A
Dynamic SuperCardioïde

photo_599

  • Tailored frequency response provides drums, guitars, vocals, and horns with studio quality sound
  • Uniform supercardioid pattern for high gain-before-feedback and superior rejection of off–axis sound
  • Hardened steel mesh grille that facilitates use of proximity effect and resists wear and abuse
  • Neodymium magnet for high signal–to–noise ratio output
  • Minimally affected by varying load impedance
  • Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
  • Legendary Shure quality and reliability

En savoir +

SHURE SM58
Dynamic Cardioïde

photo_601

  • Frequency response tailored for vocals, with brightened midrange and bass rolloff
  • Uniform cardioid pickup pattern isolates the main sound source and minimizes background noise
  • Pneumatic shock-mount system cuts down handling noise
  • Effective, built-in spherical wind and pop filter
  • Supplied with break-resistant stand adapter which rotates 180 degrees
  • Legendary Shure quality, ruggedness and reliability
  • Cardioid (unidirectional) dynamic
  • Frequency response: 50 to 15,000 Hz

En savoir +

 

SHURE Béta56 A
Dynamic Cardioïde

photo_602

  • Tailored frequency response provides drums, amplified instruments, and horns with studio quality sound
  • Built–in stand adapter with dynamic locking system and XLR connector simplifies setup and provides greater flexibility
  • Uniform supercardioid pattern for high gain-before-feedback and superior rejection of off–axis sound
  • Compact design reduces stage clutter
  • Hardened steel mesh grille resists wear and abuseratio output
    Minimally affected by varying load impedance
  • Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
  • Legendary Shure quality and reliability

En savoir +

 

SENNHEISER E906
Dynamic SuperCardioïde

photo_624

Principe du transducteur                        dynamique
Directivité                                               supercardioïde
Réponse en fréquence                            40…18000 Hz
Sensibilité en champ libre                       2,2 mV/Pa
Impédance nominale                               350 Ohm
Impédance de charge minimale              1000 Ohm

En savoir +

 

SENNHEISER E604
Dynamic Cardioïde

photo_606

Principe du transducteur dynamique
Directivité cardioïde
Réponse en fréquence 40…..18000 Hz
Sensibilité en champ libre 1,8 mV/Pa
Impédance nominale 350 Ohm
Impédance de charge minimale 1000 Ohm
Connecteur XLR-3
Dimensions Ø 33 x 59 mm
Poids sans cable 60 g

En savoir +