RADIAL Engineering J48

 J48TM phantom powered active direct box

Exceptional headroom & dynamic range
Retains instrument's natural sound
The perfect DI for bass & acoustic guitar
Powered by 48V phantom
Ultra low distortion of all types 

→ 

NEUMANN KM184

Statique Cardioïde

 Le modèle KM 184 (de directivité cardioïde), en particulier, est devenu un classique dans le domaine des microphones miniatures de haute qualité.

→ 

SHURE SM81LC

 Statique Cardioïde

  •      0 Hz to 20 kHz frequency response
  •      Flat response curve for accurate reproduction of sound sources
  •      Low noise and high output clipping level
  •      Low distortion over a wide range of load impedances
  •      Cardioid polar pattern, uniform with frequency and symmetric about axis, providing maximum rejection and minimum coloration of off-axis sounds
  •      Low RF susceptibility
  •      Selectable low-frequency response: flat, 6 or 18 dB/octave rolloff
  •      0 dB/10 dB lockable attenuator switch
  •      Phantom powering (DIN 45 596 voltages of 12 to 48 Vdc)
  •      Rugged steel construction for durability
  •      Field-usable over wide range of temperature and humidity conditions

→ 

SHURE UR2/Béta58A

 Wirelees SuperCardioïde

  •      Supercardioid, Dynamic
  •      Frequency response: 50 to 16,000 Hz
  •      Neodymium magnet for high signal–to–noise output
  •      RF Carrier Frequency Range: 470 – 952 MHz
  •      Switchable RF Power (10/50 mW), country dependent
  •      Battery Life: Up to 9.5 hours continuous use

→ 

BEYERDINAMIC M88TG

 Dynamic Cardioïde

Transducer type Dynamic
Operating principle Pressure gradient
Frequency response (close miking) 30 - 20,000 Hz
Polar pattern Hypercardioid
Side attenuation > 23 dB at 120°
Open circuit voltage at 1 kHz (0dB = 1V/Pa) 2.9 mV/Pa ≡ -30.7 dBV
Magnetic field suspension >20 dB ≡ 50 Hz
Nominal impedance 200 Ω
Diaphragm Hostaphan®
Case/finish Brass
Connector 3-pin XLR

→ 

ElectroVoice RE20

 Dynamic Cardioïde

Element Dynamic
Polar Pattern Cardioid
Impedance, Low-Z balanced 150 Ohms
Connector Type 3-pin XLR
Open Circuit Voltage 1.5 mV/Pascal
Finish Fawn Beige
Case Material Steel
Weight Net 737 g ( 26 oz )
Dimensions (Height X Max Diameter) 217 x 54 mm
(8.54" x 2.13")

Microphone Applications:
Accordion, Acoustic Strings, Brass, Guitar Amp, Kick Drum, Snare, Speech, Tom, Woodwinds

→ 

ElectroVoice N/D468

 Dynamic SuperCardioïde

Element Dynamic
Polar Pattern Supercardioid
Impedance, Low-Z balanced 150 Ohms
Connector Type 3-pin XLR
Open Circuit Voltage 3.1 mV/Pascal
Audio Frequency Response 20 - 22,000 Hz Near Field 60 - 22,000 Hz Far Field
Mic Type Instrumental
Wired/Wireless Wired
Finish Non-reflecting Black
Case Material Metal
Weight Net 190 g ( 6.7 oz )
Dimensions (Height X Max Diameter) 115 x 52 mm
(4.53" x 2.05")

Microphone Applications:
Accordion, Acoustic Strings, Guitar Amp, Snare, Tom, Woodwinds


→ 

SENNHEISER MD441U

 Dynamic SuperCardioïde


Très grande linéarité
Suppression maximum des réactions acoustiques
Insensible aux bruits mécaniques, grâce à la suspension élastique de la capsule
Bobine de compensation du ronflement
Atténuateur de graves à 5 paliers
Commutateur de brillance
Protection anti-plosives intégrée

→ 

SENNHEISER MD421

 Dynamic Cardioïde

Principe du transducteur dynamique
Directivité cardioïde
Réponse en fréquence 30.....17000 Hz
Sensibilité en champ libre 2 mV/Pa +- 3 dB
Impédance nominale 200 Ohm
Impédance de charge minimale 200 Ohm
Connecteur XLR-3
Dimensions 215 x 46 x 49 mm

→ 

SHURE Béta91

 Statique Cardioïde

The Beta 91 combines superior "attack" and "punch" for studio quality sound, even at the extremely high sound pressure levels encountered inside a kick drum. Its boundary effect design produces a strong, solid low-end response that has been specifically tailored for heavy bass applications.

  • Frequency response shaped specifically for kick drums and other instruments
  • Wide dynamic range for use in high SPL environments
  • Low-profile design requires no external mounting hardware
  • Detachable cable for easy storage
  • Legendary Shure quality, ruggedness, and reliability

 

 

 

→ 

SHURE Béta52

 Dynamic SuperCardioïde
  • Frequency response shaped specifically for kick drums and bass instruments
  • Built–in dynamic locking stand adapter with integral XLR connector simplifies setup, especially inside a kick drum
  • Studio quality performance, even at extremely high sound pressure levels
  • Supercardioid pattern for high gain before feedback and superior rejection of unwanted noise
  • Hardened steel mesh grille that resists wear and abuse
  • Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
  • Neodymium magnet for high signal–to–noise ratio output
  • Low sensitivity to varying load impedance
  • Legendary Shure quality and reliability

→ 

SHURE SM57 LC

 Dynamic Cardioïde
  •      Contoured frequency response for clean, instrumental reproduction and rich vocal pickup
  •      Professional-quality reproduction for drum, percussion, and instrument amplifier miking
  •      Uniform cardioid pickup pattern isolates the main sound source while reducing background noise
  •      Pneumatic shock-mount system cuts down handling noise
  •      Extremely durable under the heaviest use
  •      Frequency response: 40 to 15,000 Hz

→ 

SHURE Béta57A

 Dynamic SuperCardioïde

  • Tailored frequency response provides drums, guitars, vocals, and horns with studio quality sound
  • Uniform supercardioid pattern for high gain-before-feedback and superior rejection of off–axis sound
  • Hardened steel mesh grille that facilitates use of proximity effect and resists wear and abuse
  • Neodymium magnet for high signal–to–noise ratio output
  • Minimally affected by varying load impedance
  • Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
  • Legendary Shure quality and reliability

→ 

SHURE SM58

Dynamic Cardioïde
  •       Frequency response tailored for vocals, with brightened midrange and bass rolloff
  •       Uniform cardioid pickup pattern isolates the main sound source and minimizes background noise
  •       Pneumatic shock-mount system cuts down handling noise
  •       Effective, built-in spherical wind and pop filter
  •       Supplied with break-resistant stand adapter which rotates 180 degrees
  •       Legendary Shure quality, ruggedness and reliability
  •       Cardioid (unidirectional) dynamic
  •       Frequency response: 50 to 15,000 Hz

→ 

SHURE Béta56 A

 Dynamic Cardioïde

  •       Tailored frequency response provides drums, amplified instruments, and horns with studio quality sound
  •       Built–in stand adapter with dynamic locking system and XLR connector simplifies setup and provides greater flexibility
  •       Uniform supercardioid pattern for high gain-before-feedback and superior rejection of off–axis sound
  •       Compact design reduces stage clutter
  •       Hardened steel mesh grille resists wear and abuse
  •       Neodymium magnet for high signal–to–noise ratio output
  •       Minimally affected by varying load impedance
  •       Advanced pneumatic shock mount system that minimizes transmission of mechanical noise and vibration
  •       Legendary Shure quality and reliability

→ 

SENNHEISER E906

 Dynamic SuperCardioïde


Principe du transducteur                        dynamique  
Directivité                                               supercardioïde  
Réponse en fréquence                            40...18000 Hz  
Sensibilité en champ libre                       2,2 mV/Pa  
Impédance nominale                               350 Ohm  
Impédance de charge minimale              1000 Ohm  

→ 

SENNHEISER E604

 Dynamic Cardioïde

Principe du transducteur dynamique
Directivité cardioïde
Réponse en fréquence 40.....18000 Hz
Sensibilité en champ libre 1,8 mV/Pa
Impédance nominale 350 Ohm
Impédance de charge minimale 1000 Ohm
Connecteur XLR-3
Dimensions Ø 33 x 59 mm
Poids sans cable 60 g

→ 

SENNHEISER E902

 Dynamic Cardioïde

Principe du transducteur dynamique
Directivité cardioïde
Réponse en fréquence 20...16000 Hz
Sensibilité en champ libre 0,2 mV/Pa; (60 Hz): 0,6 mV/Pa
Impédance nominale 350 Ohm
Impédance de charge minimale 1000 Ohm
Connecteur XLR-3
Dimensions 128,5 x 60 mm
Poids 440 g

→